Craftsman Lawn Mower Model 917

What should I do if the Craftsman 917 is cutting grass unevenly?

If you notice uneven cutting, verify that all wheels are set to the same cutting height using the cutting height adjustment lever. Additionally, check under the mower deck for any debris buildup that may be interfering with the blade, and clean as needed.

How do I maintain the blade on my Craftsman Model 917?

For best cutting results, keep the mower blade sharp and replace bent or damaged blades immediately. The blade bolt should be torqued to 35-40 ft. lbs. Inspect the blade regularly for wear and damage before each use.

How often should I replace the spark plug and air filter on the Craftsman 917?

Replace the spark plug annually to maintain proper engine performance. Clean or replace the air filter element as needed based on operating conditions. Regular maintenance of these components ensures reliable starting and efficient operation.

What does the warranty on the Craftsman Model 917 cover?

The warranty does not cover items that have been subjected to operator abuse or negligence. To receive full warranty value, you must maintain the mower as instructed in the manual, and perform all service and adjustment checks at least once each season. Regular maintenance is required to keep your warranty valid.

What are the specifications for the Craftsman Model 917 lawn mower?

The Craftsman 917.387210 is a 4.0 horsepower, 22-inch side discharge rotary lawn mower with a 9.05 cubic inch engine displacement. It has a fuel capacity of 1.25 quarts of unleaded regular gasoline and an oil capacity of 20 ounces. The mower features adjustable cutting height and an operator presence control bar for enhanced safety.

How do I assemble and unfold the handle on my Craftsman Model 917?

Start by removing the handle padding holding the operator presence control bar to the upper handle. Raise the handles until the lower handle section locks into the mowing position. Then raise the upper handle section into place on the lower handle and tighten the handle knob. Finally, discard the protective handle pads placed between the upper and lower sections.