HP Neverstop Laser 1000 Printer

How do I set up the HP Neverstop Laser 1000 printer for the first time?

Start by removing the packing tape, then lift the top cover and remove the orange plastic handle with the attached black sheet. Next, install the input tray, load paper, slide the cover into place, and pull out the output bin extension. Finally, plug in the printer and wait up to 1 minute for it to warm up. (Page 1-2)

How do I know when the HP Neverstop Laser 1000 is ready to print?

The printer is ready to print when the Ready light stops blinking. After plugging in the printer, it can take up to 1 minute to warm up, and you will hear a series of noises during this process, which is normal. (Page 2)

Should I press the Power button while the printer is warming up?

Do not press the Power button while the printer is warming up, as this will turn off the printer and stop the warm-up process. Wait until the Ready light stops blinking before interacting with the printer. (Page 2)

What paper sizes does the HP Neverstop Laser 1000 support?

The HP Neverstop Laser 1000 supports A4 and 8.5 x 11 inch paper sizes as indicated during the setup process. Load the appropriate paper size into the input tray before use. (Page 1)

How do I complete the full setup of my HP Neverstop Laser 1000 printer?

Download the HP Smart software to complete the printer setup by visiting 123.hp.com. Additional setup information and videos are also available online if you have trouble getting started. (Page 2)

Where can I find setup support and troubleshooting information for the HP Neverstop Laser 1000?

Setup information and videos are available online at hp.com/support/printer-setup. You can also visit 123.hp.com to download the HP Smart software needed to complete printer setup. (Page 2)