Lost Vape P22e Ursa Epoch Pod Kit

How do I refill the e-liquid in the P22E Ursa Epoch Pod Kit?

To refill, take out the pod, open the e-liquid refilling plug, refill the pod from the filling slot, seal the plug after filling, and put the pod back into the device. It is essential to prime a new coil by filling your tank with e-liquid and leaving it to stand for at least 5 minutes before vaping to allow the cotton to absorb the liquid.

What does the LED indicator mean when it flashes red 3 times?

When the LED indicator flashes red 3 times, it indicates a Low Battery error. This occurs when the battery voltage is lower than 3.3V before using the device, or lower than 2.85V while vaping, and the output will automatically cut off.

How do I reset the puff count on my device?

To reset the puff count, plug in and out the pod 3 times within 3 seconds. The peak display of puff count is 9999, and after reaching this maximum, you can reset it using this method.

How do I prime a new coil in the Ursa Epoch Pod Kit before using?

To prepare a new coil for use, fill your pod with e-liquid and let it stand for at least 5 minutes to allow the cotton inside the new coil to soak up plenty of e-liquid. This ensures an optimal first vape experience. (Page 12)

What is the Low BATTERY warning on my Ursa Epoch Pod Kit?

If your battery voltage is less than 3.3V before using or lower than 2.85V while vaping, the LED indicator will flash red three times and the device output will automatically cut off as a precautionary measure.

How do I reset puff count on my Ursa Epoch Pod Kit?

Plug in and out the pod 3 times within 3 seconds to reset the puff count. The peak display of puff count is 9,999 before resetting.