GE Universal Remote Control

How do I install batteries in my GE Universal Remote?

Pull down on the textured surface on the back of the remote and slide the battery cover downward to remove it. Insert two AAA alkaline batteries, matching the (+) and (-) marks on the batteries to the marks inside the battery compartment. Position the battery cover slightly below the opening and push upward to lock it into place.

How do I program my remote using Direct Code Entry?

First, locate and circle all codes for your device brand in the code list. Turn on the device manually, then press and hold the Setup button until the red indicator stays on. Press the device button (TV, DVR, CBL, B-RAY, AMP, or AUX), and enter the first 4-digit code. If valid, the red indicator turns off; if not, it flashes so you can re-enter. Test by pressing Power—if the device turns off, programming is complete; otherwise, repeat with the next code.

What should I do if my GE Universal Remote stops working?

First, check that the batteries are fresh and installed correctly with matching polarities. If the remote still doesn't work, reprogram it following the Direct Code Entry or Auto Code Search instructions in the manual. If problems persist, contact JASCO Customer Service at 1-800-851-8959 (U.S.) or 1-800-267-7377 (Canada).

How do I program my GE Universal Remote using direct code entry?

First, locate your device brand and codes in the code list. Turn on the device, press and hold the Setup button until the red indicator stays on, then press the device button. Enter the first 4-digit code using the number buttons—if valid, the red indicator will turn off. Test by pressing Power; if the device turns off, programming is complete. If not, repeat with the next code from the list.

What is the Auto Code Search method for programming the GE Universal Remote?

Turn on your device, press and hold Setup until the red indicator stays on, then press the device button. Point the remote at the device and press Power—the indicator will cycle through 10 codes. Press Power repeatedly until the device turns off, then press Enter to store the code. The red indicator will turn off when complete.

How do I find out what code is programmed in my GE Universal Remote?

Press the device button, then press and hold Setup until the red indicator stays on. Press the Power button once and release it. The red indicator will blink in a pattern corresponding to each digit of the code—for example, code 1234 will blink once, pause, twice, pause, three times, pause, and four times.